Ampforce Cordless Toilet Plunger Usage Guide

1. Charge via included Type-C cable until indicator turns solid green. [00:05-00:07] 
2. Remove protective transit sleeve [00:10-00:12] 
3. Tighten the stainless steel front cylinder[00:15-00:18] 
4. When installing the Toilet Head, you can first separate the plastic nuts as shown in the video and install them in sequence.[00:21-00:30] 
5. When using in the toilet, please fully insert the toilet head into the drain[00:33-00:39] 
6. Long press and hold for 3 seconds to start the device[00:40-00:41] 
7. Pull the trigger and release high-pressure gas. If it is not cleared, please try repeatedly until the drainage is normal[00:58-01:02] 
8. After use, please rinse the steel cylinder and the following parts with clean water, and store them after drying.[01:06-01:10] 

What if my device doesn’t start up？

1. Charge via included Type-C cable until indicator turns solid green
2. Long press and hold for 3 seconds to start the device（Ensure sufficient pressing time）
3. Attention: Cannot start when charging

What should I do if my device can start but cannot maintain pressure？

（The internal air pump can be heard operating, but the pressure gauge consistently reads zero.）

1. Check whether the piston has become detached.
2. Inspect if the seal ring is detached or improperly installed. If issues are found, remove the seal ring and reinstall it properly.